Hello, I have just upgraded to a CM15 with AHP and am starting to think I should not have bothered.
Apologies if this is covered before but I cannot find the answer in a search.
I have a problem with some of my timers. In the morning three of them seem to be turning off early and it is driving me crazy. They come on at 6:15 and should go off at around 7 but switch off around 6.45 in the correct order, about a minute between each as they should. I have tried reinstalling following a complete uninstal as per the x10 wiki, different versions of AHP and even seperate off timers rather than a combined on/off.
Other timers seem to come on and off fine ie the bedside lamp at 6 'till 6.20 and I use one of the problem ones which works fine from dusk 'till 10PM each night.
When I clear the interface with AHP should it then show empty? Mine still seems to be using memory for timers, macros and dusk to dawn. I have tried removing the battery and leaving it unplugged etc.
Any ideas appreciated before I give in and send this back, I bought this so I could set up some smartmacros but have crashed and burned way before I got it set up to do the basics of the CM12 system I was using.
Thanks, Chris
Apologies if this is covered before but I cannot find the answer in a search.
I have a problem with some of my timers. In the morning three of them seem to be turning off early and it is driving me crazy. They come on at 6:15 and should go off at around 7 but switch off around 6.45 in the correct order, about a minute between each as they should. I have tried reinstalling following a complete uninstal as per the x10 wiki, different versions of AHP and even seperate off timers rather than a combined on/off.
Other timers seem to come on and off fine ie the bedside lamp at 6 'till 6.20 and I use one of the problem ones which works fine from dusk 'till 10PM each night.
When I clear the interface with AHP should it then show empty? Mine still seems to be using memory for timers, macros and dusk to dawn. I have tried removing the battery and leaving it unplugged etc.
Any ideas appreciated before I give in and send this back, I bought this so I could set up some smartmacros but have crashed and burned way before I got it set up to do the basics of the CM12 system I was using.
Thanks, Chris
Comment