I have a couple of pressure pads on consecutive stair treads linked to a direction detector. The set up works well except when starting the network. On network start the dectector always registers "in" even though looking at the log for the pads they don't show any activity.
I wonder if it's related to the fact the pads seem to register 1 when not stepped on and 0 when stepped on (which means I have the "invert input" boxes checked in the direction detector). Is there a way to inhibit the direction detector during start up or is there a better way?
Thanks,
Peter
I wonder if it's related to the fact the pads seem to register 1 when not stepped on and 0 when stepped on (which means I have the "invert input" boxes checked in the direction detector). Is there a way to inhibit the direction detector during start up or is there a better way?
Thanks,
Peter
Comment