Hi All,
Anyone have an idea on how to use the reset button on the above?
Reason for asking, reusing this module, but it's got the same NodeID/hex address as an existing panel.
Didn't realise until I plugged it in.
And I've given the reset button a go with the Node plugged in, just pressing it, also pressing and holding for several seconds etc, but didn't seem to do anything.
I also did actually try unplugging it,
Tools > Node profile utility...
reading the existing node on the network with same ID
Expand Max NID's (Node ID's) ...
select NID 01 ...
right-click - change all IDs and Save profile to a new unused hex address
But upon replugging the old node in, I received in the Communications window:
"< Ground Floor Bathroom GL1 (Power-up)
< 9107103CCC0571042A"
Which wasn't what I was expecting.
Cheers,
Marcus
Anyone have an idea on how to use the reset button on the above?
Reason for asking, reusing this module, but it's got the same NodeID/hex address as an existing panel.
Didn't realise until I plugged it in.
And I've given the reset button a go with the Node plugged in, just pressing it, also pressing and holding for several seconds etc, but didn't seem to do anything.
I also did actually try unplugging it,
Tools > Node profile utility...
reading the existing node on the network with same ID
Expand Max NID's (Node ID's) ...
select NID 01 ...
right-click - change all IDs and Save profile to a new unused hex address
But upon replugging the old node in, I received in the Communications window:
"< Ground Floor Bathroom GL1 (Power-up)
< 9107103CCC0571042A"
Which wasn't what I was expecting.
Cheers,
Marcus
Comment