Hi there,

I currently have a house setup on a S Plan Plus system using 2 x Honeywell CM927's speaking back to 2 x HC60NG at the boiler. I'd like to consider moving to EvoHome to allow me to centrally control it and to start adding HR80 radiator controllers to zone the house a bit more.

Any ideas on a way to migrate to this a bit at a time ?

I was thinking I could get the EvoHome controller and bind it to the 2 HC60's and then turn the CM927's into temperature controls only first off ? and then start adding HR80s a couple of rooms at a time ?

Or, could I start by ading HR80s to the CM927s a room at a time and then the EvoHome ?

Then finally change out the CM927s for DT92s ?

Thanks,
Roy.