Hi,
I'm no plumbing expert but i need to replace the thermostat with a controller so we can manage the heating better.
The thermostat is quite old as far as i can tell, the boiler we have is a ariston combi a/23.
I was wanting to replace the thermostat with a Honeywell ST9100C.
From the images attached does this look possible without installing new wiring? The thermostat is currently located in the hall way about 6 meters from the boiler and its the only thermostat in the house.
The picture of the corroded pipe is just for advice, we have a problem with the hot water supply if you put a tap on but not fully on the pressure seems to drop and the pipes start vibrating and banging, if you put the hot water taps on full it doesnt come out as hot as not opening the tap fully.
I have since disconnected the pipe and put PTFE tape in the corroded connection to stop it leaking as bad and is manageable now till i can get a permanent solution
Many thanks in advance!!
Matt
I'm no plumbing expert but i need to replace the thermostat with a controller so we can manage the heating better.
The thermostat is quite old as far as i can tell, the boiler we have is a ariston combi a/23.
I was wanting to replace the thermostat with a Honeywell ST9100C.
From the images attached does this look possible without installing new wiring? The thermostat is currently located in the hall way about 6 meters from the boiler and its the only thermostat in the house.
The picture of the corroded pipe is just for advice, we have a problem with the hot water supply if you put a tap on but not fully on the pressure seems to drop and the pipes start vibrating and banging, if you put the hot water taps on full it doesnt come out as hot as not opening the tap fully.
I have since disconnected the pipe and put PTFE tape in the corroded connection to stop it leaking as bad and is manageable now till i can get a permanent solution
Many thanks in advance!!
Matt
Comment