Hi All,
I have a number of QLD/QRIs setup running from a combination of motion sensors and switches.
I have found that I have a requirement to be able to periodically alter the Room "Occupied time out" parameter. For example in the bathroom I would like to set the timeout value to a large value during the day/early evening to accommodate bath time but would like to reset this to a much shorter value through the night for those early hour visits to the loo.
I have looked into doing this via a macro or scheduled event but have had no luck. Is this possible at all?
Regards
Mark
I have a number of QLD/QRIs setup running from a combination of motion sensors and switches.
I have found that I have a requirement to be able to periodically alter the Room "Occupied time out" parameter. For example in the bathroom I would like to set the timeout value to a large value during the day/early evening to accommodate bath time but would like to reset this to a much shorter value through the night for those early hour visits to the loo.
I have looked into doing this via a macro or scheduled event but have had no luck. Is this possible at all?
Regards
Mark
Comment