If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Honeywell BD91 (used with evohome) - "Min 30cms apart"
Do you have boiler relay and heating valve relay? Did you check that the binding was deleted at the evohome under system devices?
I have three BDR's HW/CH/UF and three Honeywell S plan zone valves and wireless temp. Base unit factory reset and all BDR's memory cleared. How much more can you do??
I have three BDR's HW/CH/UF and three Honeywell S plan zone valves and wireless temp. Base unit factory reset and all BDR's memory cleared. How much more can you do??
That's a complex system
The error will be in the binding
If you can send me a sketch of how the system is arranged I can help
I work for Resideo, posts are personal and my own views.
If you can send me a sketch of how the system is arranged I can help
The CH BDR is bound at the system level with 8 rad controllers. The HW is zone 2 port and wired via tank immersion safety. The UF is obviously on its own zone valve.
Should the HW not be on its own, if I do this though I lose app control of turning it on and off.
Comment