Results 1 to 2 of 2

Thread: x10 2nd generation programming

  1. #1
    Automated Home Jr Member
    Join Date
    Jul 2011
    Posts
    12

    Default x10 2nd generation programming

    Hello, any tips for programming 2nd generation lamp modules that have lost their setting.
    I have a few that have stopped responding to the signal to program the house code and number.

    is it possible to clear/reset the memory of these modules?

  2. #2
    Automated Home Legend TimH's Avatar
    Join Date
    Feb 2004
    Location
    UK
    Posts
    503

    Default

    Quote Originally Posted by shonen View Post
    Hello, any tips for programming 2nd generation lamp modules that have lost their setting.
    I have a few that have stopped responding to the signal to program the house code and number.

    is it possible to clear/reset the memory of these modules?
    Hi Shonen,

    Not sure what specific modules you have but you could try re-assigning the house codes you want (or set to something else, then re-set to what you want).
    These instructions were posted elsewhere, but might help you
    I think it will be the 2nd step that's most important for you - ensuring you send the new code within a short time of applying power to the module.

    * Press the ON button (corresponding to the Unit Code you want the LM15 to respond to) on the X-10 controller three times, at about one second intervals. On the third press, the lamp will turn on signifying that the code has been learnt.
    * To change the code that the LM15 responds to, turn off the power to the unit, turn it back on and repeat the previous step within 30 seconds after applying power.

    HTH, please post back if it works for you.

    Cheers,
    Tim.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •