I have found a bug with the app (running android). I have mentioned before there is a long lag between hot water reading updates being referred from the controller to the app (via the gateway).
I was trying to switch the hot water on (forced over-ride) using the app and was greeted with "No thermostat connected in this zone". I then went to the controller, and switched the hot water on without any issue. I tried the app several times, and about 10 minutes later it started working again allowing me to adjust the hot water. This isn't a one-off...it has happened every now and then....it always eventually starts working again a few minutes later.
I think what is happening is that the app is not getting the frequency of updates it expects from the controller for the hot water and so falls into this error condition.
Heating temperatures are nicely relayed between controller to app...no issues there. The hot water probe transmitter reports a full 5 level signal.
I was trying to switch the hot water on (forced over-ride) using the app and was greeted with "No thermostat connected in this zone". I then went to the controller, and switched the hot water on without any issue. I tried the app several times, and about 10 minutes later it started working again allowing me to adjust the hot water. This isn't a one-off...it has happened every now and then....it always eventually starts working again a few minutes later.
I think what is happening is that the app is not getting the frequency of updates it expects from the controller for the hot water and so falls into this error condition.
Heating temperatures are nicely relayed between controller to app...no issues there. The hot water probe transmitter reports a full 5 level signal.
Comment