Results 1 to 2 of 2

Thread: xPL Plugin Update

  1. #1
    Automated Home Guru FrankMcAlinden's Avatar
    Join Date
    Feb 2004
    Location
    Melbourne Australia
    Posts
    109

    Default xPL Plugin Update

    Hi All
    Would just like to mention the xPL Plugin for the Probe system has been updated to allow users to select the temps to be reported in either C or F ...
    Also New ..There are now 16 user programmable auto polling commands. For each auto poll command the user enters Zone,Probe,Minutes.........

    More Soon

    Frank
    Home of FirM - the Multi Zone IR Transport System
    http://www.armaghelectrical.com.au/index.html

  2. #2
    Automated Home Guru FrankMcAlinden's Avatar
    Join Date
    Feb 2004
    Location
    Melbourne Australia
    Posts
    109

    Default Re: xPL Plugin Update

    Also forgot to Mention

    There is a programmable High and Lo setting for each temp probe . So for instance probe 5 on zone 1 could be set at say 18 C for Low and 25 C for high..

    When the probe is polled and its temp is 18 C or less it will add an alert =low tag to the message and likewise if the probe is polled and the temp is 25 or higher it will add an alert=high to the message.

    In my own installation i use these alert messages to start and stop my CBUS controlled bedroom sweep fans....Works quite well....

    The bedroom temp sensors are polled every 15minutes whereas i poll my node 0 temp sensor every 5 minutes....

    Frank
    Home of FirM - the Multi Zone IR Transport System
    http://www.armaghelectrical.com.au/index.html

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •