Just wired in a LM12W and it works fine with X10 ie on/off/dim by remote control and the local (traditional) wall switch turns the lamp off but when the local switch is switched back on, the lamp does not light until it receives an X10 'on' command.
Is this how the module is supposed to work?
If so if I wire in an AM12W instead will I be able to turn the lamp both off and on using the local switch without having to send an X10 signal?
Is this how the module is supposed to work?
If so if I wire in an AM12W instead will I be able to turn the lamp both off and on using the local switch without having to send an X10 signal?
Comment