Results 1 to 3 of 3

Thread: Installing a new device with z-way never gets past "Configuring device"

  1. #1
    Automated Home Jr Member Stubbs's Avatar
    Join Date
    Jan 2004
    Posts
    47

    Question Installing a new device with z-way never gets past "Configuring device"

    I'm trying to install a new device (my first), it's a Fibaro universal sensor and the controller is a Razberry daughter board installed on a Raspberry PI..

    I start the inclusion via the z-way interface, push the "B" button 3 times & it is found, then it goes to "Configuring device please wait ..." and that's as far as it gets.

    I've uploaded the logs http://pastebin.com/w5RBGgWA, including the bit where I excluded it after the last attempt to add it.

    I'm running the device off a 9V battery at the moment on my bench while I get it all set up, I notice 9V is the minimum voltage, could that be effecting it?

    If I browse back to the UI after a while, it does list the device & it's sensor (2 buttons & 3 "sensors") but I can't get the buttons to register an event when I trigger them, I'm assuming this is down to the problem setting it up though. It also reports that the interview is incomplete, I assume that's what's going on during the configuration phase above.

    What should I try next?
    -S

  2. #2

  3. #3
    Automated Home Jr Member Stubbs's Avatar
    Join Date
    Jan 2004
    Posts
    47

    Default

    Tried that now Mark, and I get the same problem.
    -S

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •