Solid red light on BDR91?

[Andehh]

I have a solid red light, with the occasional green flash on my RAD's BDR91. This is a new install so starting everything fresh.

The unit is installed a full 400mm from anything metal, and the BDR91 400mm away controlling the hot water seems to be working fine.

I have tried a full reset (pressing & holding for 15secs) several times, as well as full reset on the Evohome controller, and deleting the RAD zones etc.Nothing seems to clear it.

Binding the RAD controllers to it, fails to work/do anything.

Any suggestions?

Thanks

[Andehh]

Now it flashes RED, but I still can't get it to bind/communicate.

It just refuses to receive a signal from my Evohome controller, despite being well away from anything metal/device wise!


edit: it is the rear BDR91 with the red light shown that's flashing.



20151021_184816 (1).jpg

[Andehh]

Right, I have swapped the 2 face plates over, and the red flashing stays with the ''dodgy'' BDR91. Holding it down for 15seconds doesnt clear this, which makes me assume I need to try and find a way of ''hard'' resetting the memory.

The mystery deepens....


Still can't figure this thing out, and have no heating until then. If anyone can shed any light on this I would be very grateful!

[top brake]

I have a solid red light, with the occasional green flash on my RAD's BDR91. This is a new install so starting everything fresh.

The unit is installed a full 400mm from anything metal, and the BDR91 400mm away controlling the hot water seems to be working fine.

I have tried a full reset (pressing & holding for 15secs) several times, as well as full reset on the Evohome controller, and deleting the RAD zones etc.Nothing seems to clear it.

Binding the RAD controllers to it, fails to work/do anything.

Any suggestions?

Thanks

sounds like incorrect binding

recommend that you take the youlearm training (link in my sig)

[Andehh]

\ignore this, just trying something...