Hi
I am a gas engineer(no electrical experience) who has just installed a
worcester 35 cdi
worcester 300 ltr unvented cylinder
s plan
underfloor heating with 5 zones
currently 3 radiators with hr92
zone valve to underfloor heating manifold
zone valve to hot water
hr92's controlling upstairs radiators
I have
honeywell evohome
honeywell underfloor heating controller
boiler relay
hot water pack
network pack
An experienced boiler electrician did the installation for me although he is not experienced with evo home but had some advice by a kind chap from the evohome shop
My issue is i get a lot of coms faults (daily) mainly boiler relay which is becoming frustrating
The bdr's are 300mm apart and at least 300mm away from boiler cylinder and pipework.
Anyone have any suggestions or know any evo home experts that work in kent I could get round
One other thing is i went into advanced settings do an rf test. if i do rf test on heating both bdr's flash red, is that correct.
I will upload some pics of my installation shortly
Thanks for any advice
Darren
I am a gas engineer(no electrical experience) who has just installed a
worcester 35 cdi
worcester 300 ltr unvented cylinder
s plan
underfloor heating with 5 zones
currently 3 radiators with hr92
zone valve to underfloor heating manifold
zone valve to hot water
hr92's controlling upstairs radiators
I have
honeywell evohome
honeywell underfloor heating controller
boiler relay
hot water pack
network pack
An experienced boiler electrician did the installation for me although he is not experienced with evo home but had some advice by a kind chap from the evohome shop
My issue is i get a lot of coms faults (daily) mainly boiler relay which is becoming frustrating
The bdr's are 300mm apart and at least 300mm away from boiler cylinder and pipework.
Anyone have any suggestions or know any evo home experts that work in kent I could get round
One other thing is i went into advanced settings do an rf test. if i do rf test on heating both bdr's flash red, is that correct.
I will upload some pics of my installation shortly
Thanks for any advice
Darren
Comment