If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I would delete both zones on the controller, and then UNBIND the 4 HR92s just to make sure. Re-build the zones as per the Evohome instructions.
Sorry to ask an obvious question but how do I properly unbind?
Think I did it wrong thing first time, thanks? Also I've just did an rf. Comms check on all my zones and they all came back negative which concerns me as system is working fine.. Thanks again..
Sorry to ask an obvious question but how do I properly unbind?
Think I did it wrong thing first time, thanks? Also I've just did an rf. Comms check on all my zones and they all came back negative which concerns me as system is working fine.. Thanks again..
Clearing binding at the HR92
1. Press the button.
2. Hold the button pressed for 5 seconds.
3. Select bind using the adjustment dial and keep the
button pressed until cleared is displayed. Binding is deactivated.
Comment