Hi,
I’m in the process of installing an Evohome system to control my heating and hot water (Controller, Hot Water kit and 16 HR92s). I have an S Plan setup with a system boiler (Glow Worm Ultracom2 30SXI with vented cylinder). I’d like to get input on whether I’ve understood the wiring diagrams for my intended setup. I’m aiming to achieve the Figure 4 setup in the Installation Guide, with the current CH zone valve isolated and locked open and HR92s fitted to all radiators in the house. I’ve attempted to simplify the Figure 9 wiring diagram for my setup (note my boiler requires a permanent live feed and has a 230V Room Thermostat connection). Does this look correct or have I missed out any key connections? I’m worried that it looks a bit too simplified!
Wiring2.jpg
Thanks,
Dan
I’m in the process of installing an Evohome system to control my heating and hot water (Controller, Hot Water kit and 16 HR92s). I have an S Plan setup with a system boiler (Glow Worm Ultracom2 30SXI with vented cylinder). I’d like to get input on whether I’ve understood the wiring diagrams for my intended setup. I’m aiming to achieve the Figure 4 setup in the Installation Guide, with the current CH zone valve isolated and locked open and HR92s fitted to all radiators in the house. I’ve attempted to simplify the Figure 9 wiring diagram for my setup (note my boiler requires a permanent live feed and has a 230V Room Thermostat connection). Does this look correct or have I missed out any key connections? I’m worried that it looks a bit too simplified!
Wiring2.jpg
Thanks,
Dan
Comment