My kitchen has two radiators, both have been controlled by HR92's up to now but one is in direct sunlight so gives an artificially high reading, the other is situated in a bad draught (old house) as its in a small corridor, so constantly gives an artificially low reading. So the kitchen temperature is never anywhere near right.
When I bind the DT92 as the sensor, it seems like it will only let me bind one radiator as an actuator - there's no option to add a further actuator - is this correct?
Is there any way to have a DT92 (or Y87RF) as a sensor and have two HR92's as actuators in one zone?
Thanks
When I bind the DT92 as the sensor, it seems like it will only let me bind one radiator as an actuator - there's no option to add a further actuator - is this correct?
Is there any way to have a DT92 (or Y87RF) as a sensor and have two HR92's as actuators in one zone?
Thanks
Comment