Have just replaced my timer clock and allowed the Evohome to fire up the boiler when it needs to.
Now i am always not happy when the boiler is fired up when I didnt think it was needed.
Today i saw the CH relay switched on but all the zones were either at or above the set point. So why was the boiler on? Switching things to Eco and then immediately the CH was switched off.
So how do I figure out which zone was actually making the call for heat. I know someone built an interface from one of the relays to read the evohome traffic between the controller and the relay. But is there an easier way?
P.S. Why oh Why Honeywell are the Quick Action temperatures not configurable! I miss my Hometronic on these occasions.
Now i am always not happy when the boiler is fired up when I didnt think it was needed.
Today i saw the CH relay switched on but all the zones were either at or above the set point. So why was the boiler on? Switching things to Eco and then immediately the CH was switched off.
So how do I figure out which zone was actually making the call for heat. I know someone built an interface from one of the relays to read the evohome traffic between the controller and the relay. But is there an easier way?
P.S. Why oh Why Honeywell are the Quick Action temperatures not configurable! I miss my Hometronic on these occasions.
Comment