Hello,
I'm a Belgium newbie is X10 technology.
I control my LD11 with a CM11USB module.
When I use Activehome with macro, the dimmer function have some strange behavior. I know you have two mode, relative and absolute but it seems when you dim several time with e.g. 20%, after it becomes difficult to bright with 30%, ...
Have you experience with this kind of feature.
I think the problem can come with the 'memory' dimmer inside the LD11 vs the LD10...
In resume, I would create 3 'light' zones in a room and create a scenario like this : Push a button on an IR remote control with the IR7243 interface and execute : zone1 dim from 100% to 30%, zone2 dim from 100% to 50%, zone3 dim from 100% to 30%, after z1 dim to off, Z3 dim to off and z2 dim to off. This scenario would be stored in the CM11 module to operate in stand alone mode, without a PC connected.
Thanks for your help.
Asterix !
I'm a Belgium newbie is X10 technology.
I control my LD11 with a CM11USB module.
When I use Activehome with macro, the dimmer function have some strange behavior. I know you have two mode, relative and absolute but it seems when you dim several time with e.g. 20%, after it becomes difficult to bright with 30%, ...
Have you experience with this kind of feature.
I think the problem can come with the 'memory' dimmer inside the LD11 vs the LD10...
In resume, I would create 3 'light' zones in a room and create a scenario like this : Push a button on an IR remote control with the IR7243 interface and execute : zone1 dim from 100% to 30%, zone2 dim from 100% to 50%, zone3 dim from 100% to 30%, after z1 dim to off, Z3 dim to off and z2 dim to off. This scenario would be stored in the CM11 module to operate in stand alone mode, without a PC connected.
Thanks for your help.
Asterix !
Comment