Hi
First things first and for full disclosure....I did my own installation of the equipment, so there is no installer to blame. I have, however, RRFM'd and followed the 'youlearn' tutorials. The heating setup is working fine, both the BDR91 and the HR92s, all bound and happy. My problem is with BDR91 controlling the hot water, which was working but last night the controller showed a comms error and on the BDR91 was a flashing red light so thought I would reset and rebind it. Since then I cannot get it to bind to the controller.
I follow the instructions, go to Guided Configuration/Stored Hot Water Configuration and through to Hot Water Sensor. Then on the BDR91, hold until it flashes quickly (15 sec), keep holding until the flashing is slow (5 sec), but nothing happens on the controller and I don't see that green "Bind" icon.
So yesterday I got a (non Evohome experienced) plumber round who checked the wiring, said it is all good and tried the setup, following the instructions.....same result.
An RF Comms check for the heating components (clearly no water test option available) comes back "excellent" so I am not worried about the signal...
I have checked the forum and can't find anything addressing this, but my apologies if I missed it. Does anyone have any advice on this before I get serious wife-factor aggravation?
Marc
First things first and for full disclosure....I did my own installation of the equipment, so there is no installer to blame. I have, however, RRFM'd and followed the 'youlearn' tutorials. The heating setup is working fine, both the BDR91 and the HR92s, all bound and happy. My problem is with BDR91 controlling the hot water, which was working but last night the controller showed a comms error and on the BDR91 was a flashing red light so thought I would reset and rebind it. Since then I cannot get it to bind to the controller.
I follow the instructions, go to Guided Configuration/Stored Hot Water Configuration and through to Hot Water Sensor. Then on the BDR91, hold until it flashes quickly (15 sec), keep holding until the flashing is slow (5 sec), but nothing happens on the controller and I don't see that green "Bind" icon.
So yesterday I got a (non Evohome experienced) plumber round who checked the wiring, said it is all good and tried the setup, following the instructions.....same result.
An RF Comms check for the heating components (clearly no water test option available) comes back "excellent" so I am not worried about the signal...
I have checked the forum and can't find anything addressing this, but my apologies if I missed it. Does anyone have any advice on this before I get serious wife-factor aggravation?
Marc
Comment