Hello
I have at the moment 3 heating Zones which are supplied by 3 zone valves controlled by wireless stats simply any stat calling for heat opens its zone valve and then end position limits on Valve switch boiler on and when stat is satisfied valve closes and boiler shuts off
I am now going to install Evo I have an Evo connected pack which includes a Controller a Internet Gateway and a BDR91 Relay
I think I can use the controller as a temp sensor for one Zone say living room and use the BDR91 to switch the Zone valve and leave the end limits on valve to switch boiler
I was then going to get 2 Honeywell Stats and BDR91s like these
and use these for the other 2 Zones using the Stats as sensors and the BDRs to switch the Zone valves again leaving the end limits on valves to switch boiler
Basically can i have multiple Stats bound to EVO Controller and switching multiple Zone valves via BDR91 relays
Thanks for advise
mylesm
I have at the moment 3 heating Zones which are supplied by 3 zone valves controlled by wireless stats simply any stat calling for heat opens its zone valve and then end position limits on Valve switch boiler on and when stat is satisfied valve closes and boiler shuts off
I am now going to install Evo I have an Evo connected pack which includes a Controller a Internet Gateway and a BDR91 Relay
I think I can use the controller as a temp sensor for one Zone say living room and use the BDR91 to switch the Zone valve and leave the end limits on valve to switch boiler
I was then going to get 2 Honeywell Stats and BDR91s like these
and use these for the other 2 Zones using the Stats as sensors and the BDRs to switch the Zone valves again leaving the end limits on valves to switch boiler
Basically can i have multiple Stats bound to EVO Controller and switching multiple Zone valves via BDR91 relays
Thanks for advise
mylesm
Comment