Hi All,
I'm about to install evohome in a property I've just renovated and in need of some advice to check I've chosen the right Evo home elements.
Setup: I've got UFH on Ground (2 zones), First (2 zones) and 2nd Floor (1 zone).
There are two manifolds: 1 ground; 1 first.
I think I need:
UFH controller x 2;
Actuators MTX x 6;
Evohome base controller;
4 x Yxxxx thermostats (1 for 2 zones GF; can you use Lyric thermostats as a single zone controller?) they look nice than the others...
I've got an unvented cylinder but I don't think there is a place to put the temperature sensor.
Really grateful for any thoughts if this is correct setup and if I've missed anything.
Thank you.
I'm about to install evohome in a property I've just renovated and in need of some advice to check I've chosen the right Evo home elements.
Setup: I've got UFH on Ground (2 zones), First (2 zones) and 2nd Floor (1 zone).
There are two manifolds: 1 ground; 1 first.
I think I need:
UFH controller x 2;
Actuators MTX x 6;
Evohome base controller;
4 x Yxxxx thermostats (1 for 2 zones GF; can you use Lyric thermostats as a single zone controller?) they look nice than the others...
I've got an unvented cylinder but I don't think there is a place to put the temperature sensor.
Really grateful for any thoughts if this is correct setup and if I've missed anything.
Thank you.
Comment