Originally posted by chrisgare
View Post
Conrad Connect now supports Evohome
Collapse
X
-
Originally posted by chrisgare View PostI've had to reconnect to Honeywell and all the graphs came back - without data.
One thing I don't like as much though is before you could set the scale low and high values for the graphs, they all look not to be automatically set from 0 up to the current max value, I don't think IMHO that this is as good, I liked to have these set from say 12 up to 28 degree's which have the graphs a good level of visible difference, with them automatically set, there is less visual difference with them all being more flat because of how the scale has been set.
Does any one know how we can change the scale again as before, as I can no longer see this option in configure.
Cheers!
Comment
-
-
That really annoys me as well as all I can see now is s straight line with little variation and there is no way to change the scales. I'm amazed by this reduction in capability and cannot understand the logic if there is any (which there isn't). But, I say that to many companies I work with. I sent a strong email to a well known company yesterday castigating them about not having an address or telephone number on their contact page. Amazing. I have no plans to provide feedback to and tell Conrad their graphs are now pretty useless.
Comment
-
-
I just set up a Dashboard this morning as you can see all Temps are almost straight Lines only one increasing is Bathroom as that one is a bypass Towel Rail with no HR92 Outside temp is 14c and Boiler is Intergas Rapid 25 with Evohome and Opentherm Control HR92 Valves on all Rads except Bathroom Towel Rail
Temps.jpgAttached FilesLast edited by mylesm; 11 September 2017, 01:07 PM.
Comment
-
-
Just having a fiddle with this, on first pass it looks good! Ability to graph everything and understand the response times of each room depending on the current/requested temperature.
How do I plot both the current temperature & the demanded temperature on one graph though?
Comment
-
-
Originally posted by Andehh View PostJust having a fiddle with this, on first pass it looks good! Ability to graph everything and understand the response times of each room depending on the current/requested temperature.
How do I plot both the current temperature & the demanded temperature on one graph though?
Comment
-
-
in fact I wish Domoticz would allow graphing across Device types, then we could graph both the relays (heat demand) and the temperatures (actual and set point) in a single graph.
The thing also to note about Domoticz HW set point, it's set to 60C within the heating cycle and not the actual set value. Dan has not yet found the time to integrate the HW set point into Domoticz yet.
Comment
-
-
Originally posted by bruce_miranda View Postin fact I wish Domoticz would allow graphing across Device types, then we could graph both the relays (heat demand) and the temperatures (actual and set point) in a single graph.
The thing also to note about Domoticz HW set point, it's set to 60C within the heating cycle and not the actual set value. Dan has not yet found the time to integrate the HW set point into Domoticz yet.
What annoys me is there is no way to even manually override it on the graphs, I think it's hard coded somewhere. At least on my munin graphs I can manually set the set point for the hot water on state on the graphs to match my actual chosen hot water temperature. Makes it much easier to spot something like an overshoot.
Comment
-
Comment