xPL Plugin Update

[FrankMcAlinden]

Hi All
Would just like to mention the xPL Plugin for the Probe system has been updated to allow users to select the temps to be reported in either C or F ...
Also New ..There are now 16 user programmable auto polling commands. For each auto poll command the user enters Zone,Probe,Minutes.........

More Soon

Frank

[FrankMcAlinden]

Also forgot to Mention

There is a programmable High and Lo setting for each temp probe . So for instance probe 5 on zone 1 could be set at say 18 C for Low and 25 C for high..

When the probe is polled and its temp is 18 C or less it will add an alert =low tag to the message and likewise if the probe is polled and the temp is 25 or higher it will add an alert=high to the message.

In my own installation i use these alert messages to start and stop my CBUS controlled bedroom sweep fans....Works quite well....

The bedroom temp sensors are polled every 15minutes whereas i poll my node 0 temp sensor every 5 minutes....

Frank