xPL Plugin Update

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • FrankMcAlinden
    Automated Home Guru
    • Feb 2004
    • 109

    xPL Plugin Update

    Hi All
    Would just like to mention the xPL Plugin for the Probe system has been updated to allow users to select the temps to be reported in either C or F ...
    Also New ..There are now 16 user programmable auto polling commands. For each auto poll command the user enters Zone,Probe,Minutes.........

    More Soon

    Frank
    Home of FirM - the Multi Zone IR Transport System
    http://www.armaghelectrical.com.au/index.html
  • FrankMcAlinden
    Automated Home Guru
    • Feb 2004
    • 109

    #2
    Re: xPL Plugin Update

    Also forgot to Mention

    There is a programmable High and Lo setting for each temp probe . So for instance probe 5 on zone 1 could be set at say 18 C for Low and 25 C for high..

    When the probe is polled and its temp is 18 C or less it will add an alert =low tag to the message and likewise if the probe is polled and the temp is 25 or higher it will add an alert=high to the message.

    In my own installation i use these alert messages to start and stop my CBUS controlled bedroom sweep fans....Works quite well....

    The bedroom temp sensors are polled every 15minutes whereas i poll my node 0 temp sensor every 5 minutes....

    Frank
    Home of FirM - the Multi Zone IR Transport System
    http://www.armaghelectrical.com.au/index.html

    Comment

    Working...
    X