Is there a bug in the current version of the Honey Total Connect Comfort (TCC) App?
If I manually change a zone temperature, then later cancel that change, the zone does not revert back to the scheduled temperature setting.
E.g. The current Living Room temperature is 20.5°C (schedule is 20°C). I then increase the temperature (i.e. override the scheduled temperature) to 21°C for a few hours:
Screenshot_A.jpg
Screenshot shows the current temperature of 20.5°C (at 21:11) with a target temperature of 21°C until 23:30.
If I now cancel the manual temperature setting, the zone should revert back to the schedule, but it does not. Instead, the app displays the 21°C as the set point – as if this is the temperature in the schedule (see image below).
Screenshot_B.jpg
The schedule is shown below:
Screenshot_C.jpg
I didnt experience this issue in previous versions of the TCC app.
If I manually change a zone temperature, then later cancel that change, the zone does not revert back to the scheduled temperature setting.
E.g. The current Living Room temperature is 20.5°C (schedule is 20°C). I then increase the temperature (i.e. override the scheduled temperature) to 21°C for a few hours:
Screenshot_A.jpg
Screenshot shows the current temperature of 20.5°C (at 21:11) with a target temperature of 21°C until 23:30.
If I now cancel the manual temperature setting, the zone should revert back to the schedule, but it does not. Instead, the app displays the 21°C as the set point – as if this is the temperature in the schedule (see image below).
Screenshot_B.jpg
The schedule is shown below:
Screenshot_C.jpg
I didnt experience this issue in previous versions of the TCC app.
Comment