Yesterday I had a couple of comms faults on two zones - not that unusual given size of house. The controller was showing a little red exclamation symbol against these two zones which implied the zones were still out of communication with the controller. This puzzled me as the HR92 display looked ok.
So I thought I would clear the notifications in the controller fault screen. Immediately on clearing the controller fault log, the two zones cleared the exclamation symbol on the controller zone display.
So to me it looks like the controller log entry is somehow keeping the zone display as in a fault condition until the log entry is cleared. This made me think my firmware must have updated but I'm still on the present software release 1.00.07.01. I don't recall seeing this behaviour ever before.
Has anyone else seen this occur.
So I thought I would clear the notifications in the controller fault screen. Immediately on clearing the controller fault log, the two zones cleared the exclamation symbol on the controller zone display.
So to me it looks like the controller log entry is somehow keeping the zone display as in a fault condition until the log entry is cleared. This made me think my firmware must have updated but I'm still on the present software release 1.00.07.01. I don't recall seeing this behaviour ever before.
Has anyone else seen this occur.
Comment