Infinite Prime help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • Elduderino
    Automated Home Lurker
    • Aug 2018
    • 4

    Infinite Prime help

    Hi
    I have an Infinite Prime alarm ( Pro installed 5years ago).
    Alarm worked fine till I had to replace batteries in 2 PIR’s & a door mag. Also install/reg a Infinite w/less keypad, & a Infinite W/less smoke detector .
    All were registered/tested successfully, which pleased me no end , as I am a newbie.
    Trouble was, only the control panel speaker would work, & not the wired/wireless siren,
    So followed the INF-WES (w/less siren. It’s also wired to 12v transformer) reg instructions, & re-registered the siren. Which worked fine, sound & strobe.
    But then when I ran tests in Services(interface, Walk,transmitters) nothing worked, also all the Zones , W/less keypad, & W/less smoke alarm had been de-registered.
    I noticed (belated) that at the top of the INF-WES install instructions it says “do not install the siren until registration & testing is complete “
    So my question is do I disconnect the backup battery & 12v transformer(so it’s not connected to control panel) before re-registering & testing all zones, & devices?
    Then re-install & register the siren.
    Regards
Working...
X