Hi,
I recently installed a EvoHome system. The EvoTouch panel is installed on an ATF600 wall mount. As there was no room behind the wall mount, the existing thermostat wire was reused. Because of this the power supply of the ATF600 is installed near my boiler.
Occasionally i see a error messages in the EvoTouch log saying something like the power supply is bad. They are very concentrated in time. For hours no error, then dozens in a matter of minutes.
I guess this has something to do with the reused thermostat wire (and its length/resistance).
Any thought on this?
Greetings,
Jack
I recently installed a EvoHome system. The EvoTouch panel is installed on an ATF600 wall mount. As there was no room behind the wall mount, the existing thermostat wire was reused. Because of this the power supply of the ATF600 is installed near my boiler.
Occasionally i see a error messages in the EvoTouch log saying something like the power supply is bad. They are very concentrated in time. For hours no error, then dozens in a matter of minutes.
I guess this has something to do with the reused thermostat wire (and its length/resistance).
Any thought on this?
Greetings,
Jack
Comment