Apologies if these are simple questions but I haven't been able to locate an answer whilst searching around here.
Q1. Everything I've checked looks to be set right but my 'Zone 4 Study' shows a demand of 23 deg but an actual temp of 17 deg. The radiator is cold. The valve isn't stuck. The HR92 seems to be paired correctly but does nothing. I have cleared and rebinded the HR92 but there's no difference.
In the 'Settings - Zone Configuration - 4 Study' menu, I have selected: Heating Type - Radiator Valve, Temp Sensor - Remote Sensor, Window Open - Disabled, Local Override - Enabled, Single Room Zone.
Any ideas?
Q2. I have four zones that have two or more rads/HR92's in each. My problem is the same in each; only one radiator heats up in each of these zones.
When binding them, I did them one at a time and had a 'Success' message for each one. As each zone is large enough to be subject to temp variations at each end, I set each of these zones as multi-room as my understanding was that they could all work away independently of the other/s HR92's.
For info, the zones are as follows:
'Zone 1 Kitchen' - has two rads/HR92's at opposite ends of a big kitchen/diner.
'Zone 5 Master Bedroom' - has two rads/HR92's at opposite ends of the bedroom/dressing area.
'Zone 3 Hall/Landing & Ground-floor Toilet' - has one rad/HR92 in the hall downstairs, one rad/HR92 in the ground-floor toilet, one rad/HR92 on the first floor landing.
Again, how might I have set this up wrongly? Any ideas?
Q1. Everything I've checked looks to be set right but my 'Zone 4 Study' shows a demand of 23 deg but an actual temp of 17 deg. The radiator is cold. The valve isn't stuck. The HR92 seems to be paired correctly but does nothing. I have cleared and rebinded the HR92 but there's no difference.
In the 'Settings - Zone Configuration - 4 Study' menu, I have selected: Heating Type - Radiator Valve, Temp Sensor - Remote Sensor, Window Open - Disabled, Local Override - Enabled, Single Room Zone.
Any ideas?
Q2. I have four zones that have two or more rads/HR92's in each. My problem is the same in each; only one radiator heats up in each of these zones.
When binding them, I did them one at a time and had a 'Success' message for each one. As each zone is large enough to be subject to temp variations at each end, I set each of these zones as multi-room as my understanding was that they could all work away independently of the other/s HR92's.
For info, the zones are as follows:
'Zone 1 Kitchen' - has two rads/HR92's at opposite ends of a big kitchen/diner.
'Zone 5 Master Bedroom' - has two rads/HR92's at opposite ends of the bedroom/dressing area.
'Zone 3 Hall/Landing & Ground-floor Toilet' - has one rad/HR92 in the hall downstairs, one rad/HR92 in the ground-floor toilet, one rad/HR92 on the first floor landing.
Again, how might I have set this up wrongly? Any ideas?
Comment