I have two Zones of UFH; Kitchen & Bathrooms. When I Turn on the kitchens, Zone 1 lights up on the HCC80R as expected, and the flow valves open for Zone 1. It shuts off no problems afterwards. However, when I turn on Zone 2, the Zone 2 lights up but both the Zone 1 and Zone 2 valves open. I reset the system a few days ago to diagnose another problem.
Zone 1 is controlled via a T87RF2033
Zone 2 is controlled via the Evohome main controller.
To correct this, I deleted my Zone 2. Re-added the zone, re-bound it to Zone 2 on the HCC80R (using Evohome COntroller as the 'stat), whilst following these instructions:
Capture.jpg
However, for the life of me I can't get get the same outcome as the instructions.
First time I tried it, I press & hold the Button for 3 seconds, this flashed Zone 1 as red, I press it again and light flashes green. I pressed it again to get me to 'Zone 2' which I am trying to set up. Now I am 'on' Zone 2, the light is flashing 'Red' at me. I press it again and it flashes 'Green' at me - any more presses and it moves onto Zone 3 etc.....
Now, the instructions says light should be flashing 'Red', so I go back and go with the 'Red' light flashing.
So, If I press 'Bind' on the controller on the 'Red' Flashing light I get the combination of Orange 'Mode' light and 'Red' zone light. With this, I go to 'step 2' of instructions and follow IT through... but the end outcome is I get Orange Mode light and Red zone light. Try it again, same outcome.
If I go back & re-do it, but press 'Bind' on the 'Green' flashing light I get the combination of Orange 'Mode' light and 'Orange' zone light.
I can't seem to get to a 'Green' Zone light despite following instructions to the letter.
Can anyone advise?
Many thanks,
edit: if still not clear, I will setup a video showing my steps vs instruction steps. I am puzzled by this.
Zone 1 is controlled via a T87RF2033
Zone 2 is controlled via the Evohome main controller.
To correct this, I deleted my Zone 2. Re-added the zone, re-bound it to Zone 2 on the HCC80R (using Evohome COntroller as the 'stat), whilst following these instructions:
Capture.jpg
However, for the life of me I can't get get the same outcome as the instructions.
First time I tried it, I press & hold the Button for 3 seconds, this flashed Zone 1 as red, I press it again and light flashes green. I pressed it again to get me to 'Zone 2' which I am trying to set up. Now I am 'on' Zone 2, the light is flashing 'Red' at me. I press it again and it flashes 'Green' at me - any more presses and it moves onto Zone 3 etc.....
Now, the instructions says light should be flashing 'Red', so I go back and go with the 'Red' light flashing.
So, If I press 'Bind' on the controller on the 'Red' Flashing light I get the combination of Orange 'Mode' light and 'Red' zone light. With this, I go to 'step 2' of instructions and follow IT through... but the end outcome is I get Orange Mode light and Red zone light. Try it again, same outcome.
If I go back & re-do it, but press 'Bind' on the 'Green' flashing light I get the combination of Orange 'Mode' light and 'Orange' zone light.
I can't seem to get to a 'Green' Zone light despite following instructions to the letter.
Can anyone advise?
Many thanks,
edit: if still not clear, I will setup a video showing my steps vs instruction steps. I am puzzled by this.
Comment