As a few of you may remember, I have had random issues with RF getting saturated leading to multiple zone failures. I have put it down to a faulty dts92 and today I have a replacement ready to setup.
Just seeing if anybody is out there that could suggest the best way of going about this? The zone has 3 hr92s that I’m leaving alone and one dts92 that I’m swapping.
So is it best to delete the entire zone? Or clear the binding on the old dts92 and putting the zone into binding mode on the evohome and simple placing the new dts92 in bind mode? Just looking for the easiest way as it would be a pain to delete the zone and have to re-enter all its schedules from scratch.
Thanks!
Just seeing if anybody is out there that could suggest the best way of going about this? The zone has 3 hr92s that I’m leaving alone and one dts92 that I’m swapping.
So is it best to delete the entire zone? Or clear the binding on the old dts92 and putting the zone into binding mode on the evohome and simple placing the new dts92 in bind mode? Just looking for the easiest way as it would be a pain to delete the zone and have to re-enter all its schedules from scratch.
Thanks!
Comment