The weird thing is that there were absolutely NO messages from your UFH controller in the dump that you added earlier. I don't know over what time period that dump was taken but I would have expected atleast some messages from the 02: devices if the HCE80 is indeed an 02: device like the HCC80R. It doesn't matter if you added more zones now, what would be good is to have ALL raw radio messages captured for about 4 hours. Put it in the file and upload that file somewhere so Dan and I can have a look at it. Your installation is quite interesting as a case study. We don't see many HCE80s.
I actually think the HCE80 is summing up the Heat Demand for the entire controller and sending it to the Evohome as a single Heat Demand single. And this is exactly why I have been asking to see the System Summary page for your controller. Because if that page cannot show the individual zone Heat Demands, then there is no way we can. I have been able to find everything else in your dump i.e. zone temps, set points, upper and lower maxs etc. But not the individual heat demands.
P.S. Relooked at the other thread. You defined 30:071715": { "name" : "evoGateway", "zoneId" : 240, "zoneMaster" : false} Why ? You have the V3 of the controller which doesn't need an Internet Gateway.
I actually think the HCE80 is summing up the Heat Demand for the entire controller and sending it to the Evohome as a single Heat Demand single. And this is exactly why I have been asking to see the System Summary page for your controller. Because if that page cannot show the individual zone Heat Demands, then there is no way we can. I have been able to find everything else in your dump i.e. zone temps, set points, upper and lower maxs etc. But not the individual heat demands.
P.S. Relooked at the other thread. You defined 30:071715": { "name" : "evoGateway", "zoneId" : 240, "zoneMaster" : false} Why ? You have the V3 of the controller which doesn't need an Internet Gateway.
Comment