Results 1 to 8 of 8

Thread: Actuator forgetting Blcoked status

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Automated Home Guru
    Join Date
    Dec 2013
    Posts
    141

    Default Actuator forgetting Blcoked status

    When I set Disable Local Override using the controller, in zones where I have multiple actuators (2 or 3) it reverts to Enabled at some time in the following hours. The Window Open Disable command suffers from the same issue. In zones where there is a single actuator, the commands are remembered OK.

    I've had EvoHome since day dot but have not used this capability until recently.

    Anyone else seen this as it's very annoying?
    Last edited by chrisgare; 17th February 2020 at 05:33 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •