Page 7 of 7 FirstFirst ... 234567
Results 61 to 66 of 66

Thread: Introducing the HGI80 alternative - the latest DIY kid on the block

  1. #61
    Automated Home Sr Member
    Join Date
    Jan 2018
    Posts
    57

    Default

    The second batch has almost gone. The folks who requested stock updates have had their chance and I have TWO available.

    I hope to have some more later this month - the best way to get early access to these is to request a stock update and then you'll get first notice of the new units.

  2. #62
    Automated Home Sr Member
    Join Date
    Jan 2018
    Posts
    57

    Default

    BTW. The current batch and all future ones are different.
    I've dropped support on the PCB for the green cc1101 modules,

    Instead the PCB now has bread-board friendly headers that give access to all the available atmega32u4 signals from the SSM module.

    The next FW update to evofw3 will be to abandon the arduino gui for building and switch to make.
    This removes the need for the custom arduino board definitions

    Together these should make it easier for anyone who wants to add additional hardware or use alternative platforms

  3. #63
    Automated Home Sr Member
    Join Date
    Jan 2018
    Posts
    57

  4. #64
    Automated Home Sr Member
    Join Date
    Jan 2018
    Posts
    57

    Default

    There are now 50 SSM modules in the wild! Thanks everyone

    They can be found in England, Scotland, Wales, Northern Ireland and Ireland.
    The Netherlands, Germany, Norway, Spain, Romania and Belgium.

    More stock will be available from early July.

    Very pleased that nobody has complained that their module doesn't work :-)

  5. #65
    Automated Home Guru
    Join Date
    Dec 2013
    Posts
    141

    Default

    It's been a long while since I did any programming! I have a unit now could someone please supply, or point to, a 101 guide on what software is required; where to get it from and any other setup procedures required. It sounds simple enough though once I get going and I'm sure it's buried somewhere in the chat. Cheers Chris

  6. #66
    Automated Home Legend
    Join Date
    Jul 2014
    Posts
    1,580

    Default

    Chris, It's important that people realise what they have bought. The SSM simply provides a gateway to capture, process and report all the Evohome radio traffic, in a text format. So first off, on it's own it won't do very much - unless you are super human and can decipher a string of numbers on the go. Just for a laugh, you could open any Serial port program like PuTTY or similar at the COM port that the SSM creates and you will see the SSM in action, busy doing its stuff.
    What you really want/need is something that can take that output and make sense of it. A message parser. There are a few that I am aware of.
    There is Domoticz, where you simply follow the Wiki to install it and configure the SSM like you would do the HGI80, except you have none of the driver installation hassles. This is the oldest and most stable UI that I am aware of. This will serve most people.
    Then there is Home Assistant. This is more modern and regularly maintained. This uses a custom component called evohome_cc which in turn uses evohome_rf. This is probably THE best in terms of most up to date parsing of messages.
    You can also use evohome_rf on its own, so you benefit from the latest parsers but without the pretty UI that Home Assistant brings. And this too is used by a few people.
    Lastly, there are other home grown parsers that people wrote over the years. But they tend to be less general purpose and not as well maintained.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •