Hi,
I'm running the Evohome beta software but noticed that the main zone (the display) is now automatically turned off (gray in the display, setpoint to 5) at 13.00 since yesterday.
There was nothing changed (by me) but the only difference is that the outside temperature is higher than the setpoint for that zone.
This does make sense, but it never gives a command to start using the schedule for that zone.
Also I can not simply turn that zone back to on. I will set it to continuous and than enable the program again.
Did someone already run into this issue?
Franz
I'm running the Evohome beta software but noticed that the main zone (the display) is now automatically turned off (gray in the display, setpoint to 5) at 13.00 since yesterday.
There was nothing changed (by me) but the only difference is that the outside temperature is higher than the setpoint for that zone.
This does make sense, but it never gives a command to start using the schedule for that zone.
Also I can not simply turn that zone back to on. I will set it to continuous and than enable the program again.
Did someone already run into this issue?
Franz
Comment