Like most people we have switched our heating back on with the recent cold weather.
I have a couple of DT92E wireless thermostat’s which I have noticed an issue with since the firmware was updated on our Evohome controller.
We often use the Eco mode on the DT92E which we found is ideal for just turning a rad on for an hour or two for a quick heating boost. An added benefit is if we forget to turn the rad back down the ECO mode switches things back after the preset time.
At the moment when we use the eco mode by pressing the green button on the DT92E the temperature is set to 19 degrees and the flame indicator appears with the timer counting down as normal. On the Evohome controller the room shows that this has been accepted. A few minutes later the Evohome controller has switched the temperature back to its previous set point but the little timer clock is still showing. Checking the DT92E it shows ECO mode still running and the timer counting down.
I have tried this several times but it just won’t work anymore as it did previously.
Is there something I have missed that I need to change to get this working again.
Thanks
John
I have a couple of DT92E wireless thermostat’s which I have noticed an issue with since the firmware was updated on our Evohome controller.
We often use the Eco mode on the DT92E which we found is ideal for just turning a rad on for an hour or two for a quick heating boost. An added benefit is if we forget to turn the rad back down the ECO mode switches things back after the preset time.
At the moment when we use the eco mode by pressing the green button on the DT92E the temperature is set to 19 degrees and the flame indicator appears with the timer counting down as normal. On the Evohome controller the room shows that this has been accepted. A few minutes later the Evohome controller has switched the temperature back to its previous set point but the little timer clock is still showing. Checking the DT92E it shows ECO mode still running and the timer counting down.
I have tried this several times but it just won’t work anymore as it did previously.
Is there something I have missed that I need to change to get this working again.
Thanks
John
Comment