X10 query with Visonic Powermax+

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • mike
    Automated Home Lurker
    • Jan 2006
    • 1

    X10 query with Visonic Powermax+

    Just purchased the Powermax+ and trying to use it to control a TM13 module but without success.
    I have the XM10U interface and RJ11 to RJ11 cable connected and when using the KR22 remote control the red light flashes to indicate the signal is being received.
    But when trying to use the Powermax to control the light nothing happens.
    The lamp attached to the TM13 stays off.
    Can anyone advise what settings are required on the Powermax ?
    ie do i disable 3 phase ?
    I have followed the manual closely and believe i have got everything else setup ok.
    Any advice will be much appreciated.

    Regards

    Mike
Working...
X