If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have my hot water set point at 55 degrees but domoticz shows it at 60, I have a 5 degree differential set, is something wrong or is it adding the differential to the set point for some strange reason?
I have my hot water set point at 55 degrees but domoticz shows it at 60, I have a 5 degree differential set, is something wrong or is it adding the differential to the set point for some strange reason?
[ATTACH=CONFIG]1883[/ATTACH]
There's no way to read the hot water set point through the Honeywell Web API's, the only information made available is the currently measured temperature and whether the hot water schedule is currently on or off.
In my own graphing scripts I've hard coded my hot water set point into the script just to make my graphs looking correct.
It's possible to retrieve the hot water set point if you use direct RF comms to the controller instead of using Honeywell's API, however I'm not sure whether Domoticz currently makes use of this. (Sounds like it doesn't, but it's a long time since I've used Domoticz)
Domoticz can show the actual set, I know because I coded that feature in :-). But as Simon as, it can only get that if you have the RF interface and not the API.
Comment