I have had Evohome installed for a few years and all had been good. Our old boiled died the other day and we had a worcester greenstar 8000 life 35kw installed.
Our system consists of
Unvented Cylinder
2 x BDR91
1 x Evohome Hot Water Control Kit
2 x 2 Port Motorised Valves, one for CH and one for HW
HR92 on all radiators.
I had to go through the settings again once the boiler was installed, it works for half a day or so and then when i go into the system summary it shows a red triangle in the boiler control, if i clear the binding and re bind it works again.
Is this just operator error and should i just run though the configurator? this then gives me no options on the boiler control.
Thanks
Mark
Our system consists of
Unvented Cylinder
2 x BDR91
1 x Evohome Hot Water Control Kit
2 x 2 Port Motorised Valves, one for CH and one for HW
HR92 on all radiators.
I had to go through the settings again once the boiler was installed, it works for half a day or so and then when i go into the system summary it shows a red triangle in the boiler control, if i clear the binding and re bind it works again.
Is this just operator error and should i just run though the configurator? this then gives me no options on the boiler control.
Thanks
Mark
Comment