-
10th November 2022, 07:33 PM
#1
Automated Home Jr Member
Honeywell Evohome Remote Gateway Comm Fault
Hi
I have a Honeywell Evohome Zone Heating since 2015, but the system keeps displaying in the controller that there is a "Comms Fault" with the Remote Gateway. It is also being problematic with not switching the heating on at the scheduled time, and then having to press the reset button to close the heating off as it stays on.
From the controller, I have rebound the Gateway to the Controller and it always says it was successful. So, I am completely confused as to why it is doing this - I can't think of any other devices that is transmitting a radio signal which could confuse it apart from a Blink Camera System but I have had it for a while and if it did I am sure it would have shown itself up much earlier.
Does anyone have any good ideas to fix this?
Thanks
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules