Hi, I have just had wet underfloor heating installed and added to my existing heating system, the plumber has installed a Polypipe ZRU PB970028 connected to a BDR91 and a evohome room temp sensor. I am just trying to switch everything on but wanted to check the settings to use.
In the settings on the Evohome controller I have connected the temp sensor, all good but the valve I am unsure to select which heating type, mixing or zone valve? If I try to bind as a zone valve the BDR91 connects but if I try mixing valve it does not bind.
I am also unsure if this setup is correct as I am unsure if this valve opens and closes but I am sure someone can advise.
Any help would be appreciated.
Mark
In the settings on the Evohome controller I have connected the temp sensor, all good but the valve I am unsure to select which heating type, mixing or zone valve? If I try to bind as a zone valve the BDR91 connects but if I try mixing valve it does not bind.
I am also unsure if this setup is correct as I am unsure if this valve opens and closes but I am sure someone can advise.
Any help would be appreciated.
Mark
Comment