Hi, I'm having trouble setting up my USB RF Controller (ZCU000) as a SUC/SIS controller. I wonder if anyone might have a solution to this.
I did two approach (both failed)... and here's the details
STEPS:
1. Reset Remote Controller - no data
2. Reset PC based Controller
Controller ID is Primary
3. Assign SC as SIS (Click 'Assign to this Node' button)
'I am SIS NOW' status
Disabled Buttons:
Create new primary
Request Update
4. Add Node
Disabled Buttons:
Create New Primary
Request Update
Assign to this Node
5. Close/Exit the application
6. Re-run application
Not SIS anymore (assigned to None)
Disabled Buttons:
Create New Primary
Request Update
Assign to this Node
*If you click SIS radio button, status is 'Could not enable SIS Assignment'
-
OR
-
1. Remote Contoller has data
2. Reset PC based Controller
Controller ID is Primary
3. Assign SC as SIS
'I am SIS NOW' status
4. Receive Information
Copy all info from the Remote Control to the PC controller
After replication/receive completed, Controller ID is now Secondary
There's no SC, only Generic Controller on the list
Disabled Buttons:
Add Node
Reset Node
Replace Failed Node
Remove Failed Node
Send Information
Create New Primary
Controller Shift
5. Close/Exit application
6. Re-run application
Error Verify module message:
Unable to Verify NodeInfo on module
Do you wish to reset module? Yes/No
No - will terminate the application
Yes - the application will reset the USB controller
DETAILS:
PC Controller is from ZWave SDK Version 4.02
Anyone has experienced this before?
Thanks
I did two approach (both failed)... and here's the details
STEPS:
1. Reset Remote Controller - no data
2. Reset PC based Controller
Controller ID is Primary
3. Assign SC as SIS (Click 'Assign to this Node' button)
'I am SIS NOW' status
Disabled Buttons:
Create new primary
Request Update
4. Add Node
Disabled Buttons:
Create New Primary
Request Update
Assign to this Node
5. Close/Exit the application
6. Re-run application
Not SIS anymore (assigned to None)
Disabled Buttons:
Create New Primary
Request Update
Assign to this Node
*If you click SIS radio button, status is 'Could not enable SIS Assignment'
-
OR
-
1. Remote Contoller has data
2. Reset PC based Controller
Controller ID is Primary
3. Assign SC as SIS
'I am SIS NOW' status
4. Receive Information
Copy all info from the Remote Control to the PC controller
After replication/receive completed, Controller ID is now Secondary
There's no SC, only Generic Controller on the list
Disabled Buttons:
Add Node
Reset Node
Replace Failed Node
Remove Failed Node
Send Information
Create New Primary
Controller Shift
5. Close/Exit application
6. Re-run application
Error Verify module message:
Unable to Verify NodeInfo on module
Do you wish to reset module? Yes/No
No - will terminate the application
Yes - the application will reset the USB controller
DETAILS:
PC Controller is from ZWave SDK Version 4.02
Anyone has experienced this before?
Thanks
Comment