I'm an X10 newbie, but I'm speccing the electricals for our new house and would like to use X10 to control lights from a remote and later on from an Ocelot or similar.
I plan to use a standard (non-X10) motion sensor, because I haven't found a wired X10 one and I want it 360 degree ceiling mounted anyway, which I have available locally.
Then I want a simple-looking wall switch like the Advanced Control Technologies TK334 (as long as it can run on 240V not 277??) and have it work as follows:
as well as:
How can I do this? Is there a nice-looking (Decora or otherwise) wall switch that can control two X10 addresses with one or two taps? Or could I use the TK334 or similar, but with some macro-capable controller?
TIA
Jonathan
I plan to use a standard (non-X10) motion sensor, because I haven't found a wired X10 one and I want it 360 degree ceiling mounted anyway, which I have available locally.
Then I want a simple-looking wall switch like the Advanced Control Technologies TK334 (as long as it can run on 240V not 277??) and have it work as follows:
- Touch ON: light goes on when motion sensor detects movement
Touch ON again: light goes on regardless (motion sensor override)
Touch OFF: light goes back onto motion sensor mode
Touch OFF again: light goes off altogether
as well as:
- press-and-hold-ON: bright
press-and-hold-OFF: dim
How can I do this? Is there a nice-looking (Decora or otherwise) wall switch that can control two X10 addresses with one or two taps? Or could I use the TK334 or similar, but with some macro-capable controller?
TIA
Jonathan
Comment