Originally posted by ally153
View Post
However this seems to be back to front from the description in the built in help which says (if I'm remembering it right - I'm not at home at the moment) full mode is recommended for well insulated houses. Above you've said that a well insulated house is probably better off not using outside temperature as a factor for scaling, which would seem to indicate use of partial mode not full mode ?
Can you clarify whether the help has its recommendation back to front or am I missing something ?
In the first beta I found full mode was too aggressive and even over time after it should have learnt it was hard to get low demand zones like the bathroom to heat up on their own. Now that manual overrides can override load scaling I might give full mode another try, however if going from partial to full mode will cause it to start taking the outside temperature into consideration and I am seeing 4-6 hour lag on the reported outside temperature, this might make things worse for me ?
Comment