Originally posted by bruce_miranda
View Post
Evohome firmware 02.00.19.31 Beta Trial - Exclusive for Automated Home Members
Collapse
X
-
Resideo employee. Comments are personal, and likely to get a hard stare from Rameses
-
-
All installed smoothly yesterday, with all the new features available.
However I had 2 zones that set themselves to 35c randomly a couple of times. Maybe just the system settling down again? Will keep observing and update. Has anyone else had this?
Comment
-
-
Just had email too, my boiler is missing too. No Glow Worms as a manufacture on list (Major boiler here in the UK too) Mine is an older model but still no manufacture. (So I've just put it down as 'Brand' and wrote name and model in Serial no section)
Oh and at the end of the email, Software HW Priority? Did I read that correctly?!
Comment
-
-
Originally posted by G4RHL View PostThe form asks for the MAC address and not the IP address. Usually I have found with things like this it is the IP address that is required.
Apart from that it is absolutely great this is being done. Thank you.
Comment
-
-
Originally posted by bruce_miranda View PostIs zone level optimisation coming back? Or is that still an All or Nothing?
Comment
-
-
Originally posted by G4RHL View PostIf optimisation has gone I won’t miss it! As I have oft reported in the past, I have tried it several times over the last 5.5 years but in my case it seemed to do nothing that the basic schedule setting was doing.
Comment
-
-
Originally posted by Andy the Minion View PostDear All, The Load scaling feature can be found in the Installer section, system parameters and everybody with a boiler bound to an ON/OFF (BDR91) boiler relay will have it.
I would recommend enabling the ‘full’ mode unless you have an extremely well insulated property.
Load scaling is a self-learning algorithm and it will take a number of heat-up cycles (maybe a week but it depends on the system and usage) to get the hang of each room. It will then continue to refine itself in parallel with the existing adaptive fuzzy logic that is already in Evo controling the steady state temperatures.
AtM
Thanks, Roy.
Comment
-
-
Thanks Andy, update received. Cold weather boost, warm weather saver and load scaling all installed with default values (where offered) accepted and applied across all zones.
My boiler model wasn't showing on the drop down list so I entered it as Bosch, a WB Greenstar 38Cdi.
Just as a side note, while I would have loved zone-level optimisation the global feature has been very effective in my set up thus far.
Comment
-
-
Originally posted by mtmcgavock View PostAlso the email -
The images are of relatively poor quality and i'm struggling to see the graphs etc. Is it possible to get them sent out in a slightly better quality? (I'm guessing you don't want them on the forum due to competitors etc) Even making them larger on the computer doesn't help!Resideo employee. Comments are personal, and likely to get a hard stare from Rameses
Comment
-
Comment